1 Posts
Hello, I have question for the forum regarding humidity controls in stability chambers. When performing temperature mapping in stability chambers, how is relative humidity handled? Any guidance out there?
1 Replies
2 Posts
Hey Yusef,
Depending on the stability chamber you purchased, most should already have a humidity controller where you can define the relative humidity for the chamber. From there you could use data loggers that record temperature and RH then perform the temperature mapping based on your defined methods or protocol
Best Regards,
Drew
Depending on the stability chamber you purchased, most should already have a humidity controller where you can define the relative humidity for the chamber. From there you could use data loggers that record temperature and RH then perform the temperature mapping based on your defined methods or protocol
Best Regards,
Drew
